CDI Torque 3/8" drive, 14.9" length

CDI Torque 3/8" drive, 14.9" length Review

CDI Torque 3/8" drive, 14.9" length Feature

• 5 - 50 ft. lb. 68 - 667 dNm 69 - 691 cmkg 60 - 600 in. lb. range
• increments .01 ft. lb. .1 dNm .1 cmkg .1 in. lb.
• Largest Storage Capacity Available Up to 4000 torque values can be stored in memory.
• An audible tone signals when memory is full. Range Available from 5 in. lb. to 1000 ft. lb.
• Calibration Data All calibration data is stored in the microprocessor.

Down Loading Capacity Computorq II is equipped to down-load individual torque values or store values in memory which can be directly down-loaded to a printer/computer or datalogger via RS232. Selectable Modes of Operation "Peak Hold" and "Track" modes of operation are standard. Computorq II's electronics are far superior to our competitors in capturing real torque value in "Peak" mode . Easy Set-Up Target torque values (high and low percentage, +/- tolerances and torque engineering units) are easily programmed through the keypad and shown on the LCD. Quality Construction Proven industrial quality. Designed for continuous use. Batteries A 9V alkaline battery is standard and provides enough power for 60 hours of operation. A "LO BAT" indication on the display signals for replacement. Accuracy +/- 1% From 20-100% of scale +/- 1%, plus 5 increments, from 10 -20% of scale. Baud Rate The baud rate for downloading to a printer/computer/data logger is selectable. The factory set rate is 1200. Options are 300, 600, 1200 2400, 4800, 9600 or 19,200. Cables: P113 - 50 - TO 9 PIN PC P113-60 - TO 25 PIN PC. Computorq-II Audio/Visual Indicators. Computorq II wrenches are equipped with both audio and visual signals in addition to the torque information supplied on the LCD. Audio Signal: An audio signal is emitted when the minimum acceptable standard indicators of high and low preset torque value is reached or the upper torque limit is exceeded. Visual Indicators: Bright green and red LED's are standard indicators of high and low preset torque limits. Over-Load Protection: The red LED flashes, the audio buzzer sounds and "OVER" is displayed on the LCD when the torque range of the wrench is exceeded. Earpiece Option: An external jack for remote earpiece signaling in noisy working environments is available as an option.